White DH User Manual

12
WHITE can accept no responsibility for possible errors in catalogues, brochures, and other printed material. WHITE reserves the right to alter its products without noce. This also applies to products already on
order provided that such alteraons can be made without subsequent changes being necessary in specicaons already agreed.
All trademarks in this material are the property of the respecve companies. WHITE and the WHITE logotype are trademarks of WHITE Drive Motors & Steering LLC and WHITE Drive Motors and Steering Sp. z o.o..
All rights reserved.
Chapter 4
Dismantling / Cleaning
Dismantling DH / DS
Item
Part to remove
Comments
7
Woodruff key
3
Seal plugs
Put the motor in a holding tool, with the output shaft downward
14, 15
Drain plug, washer (if
Use a 17 mm spanner socket.
present)
16, 17
Screws, washers
Use a 13 mm spanner socket.
12
End cover
Remove end cover sideways
9, 11
Gear wheel set, O-rings
(2 off )
Keep fingers under the gearwheel set to prevent the parts from
falling out
8
Cardan shaft
9, 10
Distributor plate, O-ring
2
Output shaft
Place the motor housing on the work bench and press the shaft
out of the motor housing. After this, turn the motor
5, 6
O-ring, bearing race
Remove bearing and bearing race from the motor housing
5
Shaft seal
With mandrel and plastic hammer, carefully knock out the shaft
seal
3
Dust seal
Table 4: Dismantling DH / DS
Cleaning
Cleaning
Clean all parts carefully with low aromac kerosine.
Inspecon and replacement
Check all parts carefully and replace if necessary.
Lubricaon
Before assembly, lubricate all parts with hydraulic oil and grease rubber parts with vaseline.

White DH Specifications

General

Brand	White
Model	DH
Category	Engine
Language	English