Why does the paddle stop rotating in my Whynter Ice Cream Maker?
If the paddle stops rotating before the timer is up in your Whynter Ice Cream Maker, it's likely because the ice cream has become too hard, causing the stir motor to get stuck. To resolve this, turn off the unit, remove the ice-cream mixing bowl, and scoop out the ice cream. Then, restart the unit; the paddle should begin rotating again.
What to do if the ice-cream mixing bowl can’t be taken out of Whynter ICM-15S?
If you're having trouble removing the ice-cream mixing bowl from your Whynter Ice Cream Maker, it's likely due to water between the bowl and the housing freezing. Wait a few minutes to allow the ice to thaw slightly, and then try removing the bowl. To prevent this in the future, ensure both the mixing bowl and the base are completely dry before making ice cream.
Why does my Whynter ICM-15S paddle make serious noise or lock up when starting?
If your Whynter Ice Cream Maker's paddle is making a lot of noise or locking up when you start it, the ice-cream mixing bowl may be deformed due to improper use. Contact the service department to check if you need to buy a new mixing bowl.
What to do if the ice-cream mixing bowl can’t be put into the ice-cream making housing of Whynter ICM-15S Ice Cream Maker?
If the ice-cream mixing bowl doesn't fit into the ice-cream making housing of your Whynter Ice Cream Maker, it might be deformed. Contact the service department to verify and purchase a new mixing bowl.
General| Brand | Whynter |
|---|---|
| Model | ICM-15S |
| Category | Ice Cream Maker |
| Language | English |
To Next Page
