17
firewood.
• Regardless of the diameter of the wood only 1 work
piece is to be put on the rocker.
• Observe all safety and hazard notes on the machine
and ensure they are kept complete and in a legible
condition.
• The machining range and surrounding areas of the
machine must be clear of interfering foreign matter
to prevent accidents occurring.
• Workpieces must be completely free of foreign ob-
jects, i.e. nails or screws.
• The circular sawbench is designed exclusively for the
machining of wood and materials similar to wood.
Only original Woodster tools and accessories may be
used. Use the required sawblade in accordance with
the EN 847-1 norm depending on the type of cut
and type of wood (solid wood, plywood or chipboard).
Please observe the „Special Tool Accessories“.
• The machine must only be used in technically perfect
condition in accordance with its designated use and
the instructions set out in the operating manual, and
only by safety-conscious persons who are fully aware
of the risks involved in operating the machine. Any
functional disorders, especially those affecting the
safety of the machine, should therefore be rectified
immediately.
• Relevant accident prevention regulations and other,
generally recognized safety-technical rules must also
be adhered to.
• The Woodster machine may only be used, main-
tained, and operated by persons familiar with it and
instructed in its operation and procedures. Arbitrary
alterations to the machine release the manufacturer
from all responsibility for any resulting damages.
• The Woodster machine may only be used with original
accessories and original tools made by the manu-
facturer.
• Any other use exceeds authorization. The manufac-
turer is not responsible for any damages resulting
from unauthorized use; risk is the sole responsibility
of the operator.Remaining hazards.
m Remaining hazards
The machine has been built using modern technology in
accordance with recognized safety rules. Some remaining
hazards, however, may still exist.
• The rotating saw blade can cause injuries to fingers
and hands if the work piece is incorrectly fed.
• Thrown work pieces can lead to injury if the work
piece is not properly secured or fed.
• Noise can be a health hazard. The permitted noise
level is exceeded when working. Be sure to wear per-
sonal protective gear such as ear protection.
• Defective saw blades can cause injuries. Regularly
inspect the structural integrity of saw blades.
• The use of incorrect or damaged mains cables can
lead to injuries caused by electricity.
• The operating instructions supplied with the special
accessories must be observed and carefully read
when Woodster special accessories are used.
To Next Page
Loading...
Need help?
General
