Worx WG157E.9 User Manual

14
2-in-1 Grass Trimmer/Edger
EN
TROUBLESHOOTING
The following table gives checks and actions that you can perform if your machine does not operate correctly.
If these do not identify and correct the problem, contact your service agent.
WARNING: Switch the machine off and remove the battery prior to any troubleshooting.
Problems Possible Causes Corrective Action
Trimmer fails to operate. Battery discharged.
Battery too hot/cold.
Motor is broken.
Internal wiring of machine damaged.
Recharge battery; also see the
content in charger manual
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Trimmer runs
intermittently.
Motor is broken.
Battery not fully charged.
On/Off switch defective.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Excessive vibrations/
noise.
Machine defective.
Line spool is not wound well.
Contact Service Agent.
Rewind the line. See ’’ To fit spool
and line assembly.’’
Cutting time per battery
charge too low.
Battery has not been used for long period
or only charged for short term.
Grass too high.
Battery defective.
Fully charge battery; also see
the content in charger manual
Cut in stages.
Replace the battery.
Machine does not cut. Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting head.
Replace the line.
Recharge battery; also see the
content in charger manual
Contact Service Agent.
Remove grass.
Continuous lighting
of the battery charge
indicator
No charging procedure
possible.
Battery not (properly) inserted.
Battery contacts contaminated.
Battery defective.
Properly insert battery into battery
charger.
Clean the battery contacts (e.g.
by inserting and removing the
battery several times) or replace the
battery.
Replace the battery.
Battery charge indicator
does not light up.
Plug of battery charger not plugged in
(properly).
Socket outlet, mains cable or battery
charger defective.
Insert mains plug (fully) into the
socket outlet.
Check the mains voltage; have
the battery charger checked by an
authorized after-sales service agent.
Auto feed does not work Cutting line is not wound well.
The line is tangled.
Line is used up.
Manually feed the line, if still can
not feed out, remove the spool out
and rewind the line.
Replace with a new line spool.

Worx WG157E.9 Specifications

General

Type	String trimmer
Cordless	Yes
Head type	Nylon line
Handle type	D-loop handle
Cutting width	250 mm
Line diameter	1.65 mm
Product color	Black, Metallic, Orange
Line length supplied	3 m
Cutting diameter (max)	- mm
Power source	Battery
Battery voltage	20 V

Weight and Dimensions

Weight	1500 g