2-in-1 Grass Trimmer/Edger EN
14
ACCESSORIES
WG184E WG184E.9
Battery pack (WA3551) 2 /
Charger (WA3883) 1 /
Spool (WA0014) 1 1
Safety guard 1 1
Edger wheels 1 1
We recommend that you purchase your accessories
listed in the above list from the same store that
sold you the lawn trimmer. Refer to the accessory
packaging for further details. Store personnel can
assist you and offer advice.
NOISE DATA
A weighted sound pressure L
pA
= 78 dB(A)
K
pA
3.0 dB (A)
A weighted sound power L
wA
= 95.4 dB(A)
K
wA
3.0 dB (A)
WEAR EAR PROTECTION
VIBRATION INFORMATION
Typical weighted vibration ah < 4 m/s2
Uncertainty K = 1.5 m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be used in a
preliminary assessment of exposure.
WARNING! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the
tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ASSEMBLY & OPERATION
Action Figure
Assembly
Assembling the Main Handle See Fig. A
Assembling the Safety Guard See Fig. B
Installing and Removing the Battery
Pack
NOTE:
• This machine will only run when
2 batteries are installed. It is
recommended to use the same two
batteries and charge the two batteries
at the same time.
• When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
See Fig. C1,
C2
Checking the battery charge
condition
NOTE: Fig. C3 only applies for the
battery pack with battery indicator
light.
See Fig. C3
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More details
can be found in charger’s manual.
See Fig. C4
Battery power indicator on the
machine
See details in BATTERY STATUS
section
See Fig. C5
Operation
To Next Page
Loading...
Need help?
General
