Worx WG191 User Manual

13” Grass Trimmer/Edger EN
12
ASSEMBLY & OPERATION
Action Figure
Assembly
Assembling the Main Handle See Fig. A
Assembling the Safety Guard See Fig. B
Installing and Removing the
Battery Park
See Fig. C1,&
C2
Checking the Battery Charge
Condition
See Fig. C3
Charging the battery pack
• More details can be found
in WA3859’s manual
See Fig. C4
Operation
Trimming
See Fig. D
Adjusting the Trimmer Head
See Fig. E1
& E2
Adjusting the Auxiliary Handle See Fig. F
Edging
See Fig.
G1~G4
Edger wheel storage See Fig H
Command feeding the line See Fig.I
Manually feeding the line See Fig. J
Replacing the trimmer Spool See Fig.,K L M
Manually winding the line
See Fig. N ,O,
P, Q
OPERATION INSTRUCTIONS
WARNING! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. COMMAND FEEDING THE LINE
(See Fig. I)
Your trimmer is equipped with a Command
Feed System. For efficiently feeding the line,
just press the command feed button until you
hear the ‘clattering’ noise of the line cutting.
The motor will shut off when pressing the
Command Feed button and will restart when
releasing the button. During that process the
line will automatically feed additional line for
cutting.
2. MANUALLY FEEDING THE LINE
(See Fig. J)
Turn off the trimmer and remove the battery.
If required, line can be fed out manually. To
operate, press and release manual Line Feed
Button, while gently pulling out the line until
it is long enough to reach the Line Cutter.
If the line extends past the Line Cutter, too
much line has been fed out. If too much line
is fed out, remove the Spool Cap and turn
Spool counter-clockwise until the line is at the
desired length.
3. MANUALLY WINDING THE LINE
(See Fig. N,O,P,Q)
Take approximately 20ft (6m) of line. Insert
.080”(2mm )of line into the Spool holes and
wind line in the direction of the arrows on
the top of the Spool. Leave approximately
4” (100mm) of line unwound and place into
the cleat. Ensure that the line is neatly coiled
on the Spool. Failure to do so will impair the
efficiency of the automatic line feed. Then fit
the Spool as described above in “Replacing
the trimmer line and Spool”
STORING YOUR GRASS
TRIMMER
Always remove the battery pack
from your trimmer after use.
TO STORE YOUR GRASS TRIMMER
The trimmer is provided with a hanging slot
for storing the trimmer on the wall.(See Fig.R)
Store in a dry place where the trimmer and
battery can be protected from damage.

Worx WG191 Specifications

General

Brand	Worx
Model	WG191
Category	Lawn Mower
Language	English