10
Cordless Lawn Mower WG773E
than 90%, the charger will automatically
recharge to make sure the capacity stays
above 90%.
NOTE: If the battery is Defective, the red
light will Flash.
BATTERY CARE
The battery in your cordless lawnmower is a 24-volt
sealed lead acid system. The mower can be stored in
any position without fear of leakage.
• Foroptimalbatterylifeandperformancethe
battery should be fully charged every 2 months
during storage
• Foroptimalbatterylifeandperformancethe
battery should be fully charged after each use
• Storethebatteryinacooldrylocation.
• Thebatterycanbesafelystoreddownto14°F
(-10°C).
• Thebatterydoesnotneedtobefullydischarged
before recharging.
• Initially2to3chargingcyclesmayberequired
after purchase to achieve maximum run time
capacity.
ADDITIONAL BATTERIES can be obtained from the
Customer Helpline.
ASSEMBLY
IMPORTANT! Before you assemble the lawn
mower, check the accessories according above
information, make sure the accessories are completed.
1. FITTING THE HANDLE (See Fig. B1, B2, B3)
1) Remove the screws(x 2) on the both side of deck.
(See Fig. B1)
2) Insert the lower handle (8) into the holes on the
deck provided.
3) Secure with the screws provided.(See Fig. B1)
4) Attach the upper handle (1) with the bolts and
Handle knobs (7) to the lower handle (8). (See Fig.
B2)
5) Screw on the two Handle knobs. Check that the
handle is FULLY secured.
NOTE: Ensure the bolts are fully inserted through the
handles before fitting the handle knobs.
6) Attach the cable clips (3) provided, to the upper
and lower handle. Insert the cable into the clips
ensuring there is enough cable slack .(See Fig. B3)
To Next Page
Loading...
Need help?
General
