14
Cordless Lawn mower EN
WG743E WG743E.X**
WP771E WP771E.X **
Voltage 40V Max.(2x20V Max.)***
No load speed 2800 / 3000 /min
Deck diameter 43cm
Cutting diameter 40cm
Front wheel
diameter
180mm
Rear wheel diameter 190mm
Cutting height
20mm-80mm
Cutting height
positions
7
Grass collection
capacity
45L
Battery type Lithium-ion
Machine Weight
(bare tool)
13.9kg
**X=1-999, A-Z, M1-M9 are only used for different
customers, there are no safe relevant changes
between these models.
***Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
SUGGESTED BATTERIES AND
CHARGERS
Category Model Capacity
20V Battery
WA3553 4.0 Ah
WA3014 4.0 Ah
20V Charger
WA3760 0.4 A
WA3860 2.0 A
WA3880 2.0 A
WA3772 2.0 A
WA3883 4.0 A
We recommend that you purchase your accessories
from the same store that sold you the tool. Choose the
type according to the work you intend to undertake.
Refer to the accessory packaging for further details.
Store personnel can assist you and offer advice.
NOISE DATA
A weighted sound pressure L
wA
= 75dB(A)
K
pA
3 dB (A)
A weighted sound power L
wA
= 89.3 dB(A)
K
wA
3 dB (A)
Wear ear protection
VIBRATION INFORMATION
Typical weighted vibration a
h
＜ 2.5 m/s
Uncertainty K = 1.5 m/s
WARNING The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used dependant on the following examples and other
variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
Using the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed
WARNING To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
To Next Page
Loading...
Need help?
General
