7
UNFOLDING THE FRAME
Undo the folding blockade (a). Unfold the frame by lifting the handle until the locks click into
position (b). WARNING: Before use, make sure that the folding mechanisms are blocked.
FOLDING THE FRAME
Remove the carry cot, stroller or seat from the frame. Release the locks on both sides of
the stroller by pressing pedal 1 first and then pedal 2. Hold the foot down on pedal 2 and
fold the trolley as shown in figure (c).
MOUNTING OF THE FRONT WHEEL
In order to mount the wheel, slide it onto the axle until the lock is engaged.
DISMOUNTING OF FRONT WHEEL
In order to take the wheel off, push the button shown on the figure, and pull the wheel
off the axis.
ATTACHING AND DISASSEMBLY OF REAR WHEELS
To attach the wheel, press the button in the centre of the wheel and slide the wheel axle
into the mounting socket. Pull on the wheel to check that it is securely attached. In order
to remove the wheel press the button in the centre of the wheel and pull it out of the
mounting socket.
WHEEL BLOCKADE
The stroller is provided with swiveling front wheels. A special lever blocks the wheel
swiveling movement. After the lever has been pressed, the wheels will only move forward.
To release the blockade, lift the lever.
INFLATING WHEELS
To inflate the wheel, unscrew the valve pin. Next, put the pump to the valve end and
inflate the wheel. The recommended tire pressure is 1.0-1.5 atm/bar.
INSTALLING OF THE BUMPER BAR
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
TAKING THE BUMPER BAR OFF
Push in the buttons of the bumper bar locks and slide its end out of the mounting holes.
The bumper bar may be tilted, when undone only from single side.
FOOTREST ADJUSTMENT
Press the buttons on both sides of footrest and adjust it to the required position.
BACKREST ADJUSTMENT
To change the position of the backrest, pull the holder upwards and move the backrest
to the desired position.
ASSEMBLYING THE SHOPPING BASKET
To mount the basket to the frame, press the plastic basket holders onto the mounting
pins, then wrap the straps around the frame tube and fasten the snap fasteners together.
BRAKE
To apply the brake: push the pedal down with your foot. To release the brake pick its bar up.
FITTING THE CARRYCOT OR SEAT UNIT
To fit the carrycot or seat unit open the adapter locks on both sides of the chassis. You
need to pull them upwards as shown in picture (a) until they click open. When the locks
are open, align the carrycot or seat unit with the locks and push it until the locks have en-
gaged (b). Caution: Before using the attached carrycot or seat unit you need to ensure
that it is properly fitted into place.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
ENGLISH
To Next Page
Loading...
Need help?
General
