12 13
For example: If you connect your bedside lamp to a Lamp Module set to Unit Code 1 and
then program Module number 1 for an On time of 7:00 AM - At 7:00 AM your bedside lamp
will turn on and the internal buzzer in the Mini Timer will sound. You can turn the buzzer off
(when you wake up) by sliding the Buzzer switch to the OFF position. You can turn off your
bedside lamp by pressing the OFF button for Module 1.
You can leave the Buzzer switch in the OFF position if you don’t want to use the wake up
feature. This will not affect any programs you have entered for Module 1.
Alternatively, if the Buzzer switch is OFF and you place the Mode switch in the Clock Set
position, you will “suspend” both the buzzer AND any times you have set for Module 1.
This is useful to suspend the wake-up function on weekends. See next page.
The backlight and the buzzer do not operate when the unit is running on the backup
batteries.
To Cancel/Snooze the wake-up alarm
When the alarm sounds at the time you have set, you can cancel it in one of two ways:
1. Slide the Buzzer switch to the OFF position. This will cancel the alarm permanently.
Slide the switch back to “ON” if you want the alarm to wake you up the next morning.
2. Press any key. This will give the “snooze” feature. Pressing any key while the buzzer is
sounding will turn the buzzer off and will automatically turn it back on in 10 minutes time.
You can do this indefi nitely.
The buzzer will automatically turn off, and stay off, after 10 minutes if you ignore it.
Any Module(s) you have installed and set to Unit Code 1 will turn On when the buzzer
sounds and will stay On after you turn the Buzzer switch to OFF or cancel buzzer using the
snooze feature. You will need to press the OFF button for number 1 to turn the Module(s)
off. Alternatively, you could program it/them to turn off later.
Suspending the wake up function
If you set channel 1 for an On time of 7:00 AM and number 1 is your bedside lamp, at
7:00 AM every day, your bedside lamp will turn on and the internal buzzer will sound. If
you turn the Buzzer switch off on Friday nights the buzzer will not wake you up the next
morning but your bedside lamp will still turn on.
To suspend the program for channel 1 turn the Buzzer switch to OFF, AND place the
Mode switch in the “Clock Set” position. The On program for BOTH the Alarm buzzer AND
the bedside lamp will then be suspended.
You can control Modules instantly with the Mode switch in the “Clock Set” position, just
as you can when it's in the RUN position, but remember to place the Mode switch back to
RUN and put the Buzzer switch back to the ON position on Sunday night to resume the
wake-up program for weekdays.
Note: Pressing the ON button for Module number 1 with the Mode switch in the RUN
position or Clock Set position does not activate the internal buzzer. This buzzer only
sounds at the times you set.
Changing the Housecode
When you fi rst plug in the Mini Timer it controls X10 Modules set to Housecode A. If you
want to change the Housecode:
1. Set the Mode switch to “Housecode Set.”
2. Press the up or down "Time" rocker to select the desired
Housecode (as shown in the display).
3. Set the Mode switch back to RUN.
Alarm settings Alarm settings
Setting the Alarm Buzzer
With the “Wake” switch in the “ON” position, any program you set for Module
number 1 will also set the internal alarm buzzer.
A bell icon will show in the display to indicate that a time for the Buzzer is set.
To Next Page
Loading...
General