99
99
9
88
88
8
1.1.
1.1.
1. Set the House Code
to ‘A’ and the Unit
Code to ‘2.’
2.2.
2.2.
2. Plug a lamp into
the Lamp Module.
3.3.
3.3.
3. Plug the Lamp
Module into a
convenient AC
outlet.
8-8-
8-8-
8-
ININ
ININ
IN
-1 L-1 L
-1 L-1 L
-1 L
EARNINGEARNING
EARNINGEARNING
EARNING
S S
S S
S
UPERUPER
UPERUPER
UPER
RR
RR
R
EMOTEEMOTE
EMOTEEMOTE
EMOTE
The 8-in-1 Learning SuperRemote allows
you to control practically everything
electrical in your home. It combines IR
technology that lets you control all your
TV, VCR, Cable and Satellite equipment
with X10 RF technology that lets you
control lamps and appliances anywhere
in your home.
To find out more about configuring the
Learning SuperRemote to work with your
audio/video equipment, see the section
titled “Setting Up your SuperRemote.”
1.1.
1.1.
1. Push the tab and lift
off the battery
cover.
2.2.
2.2.
2. Fit four AAA
batteries, taking
care to match the +
and - marks in the
battery
compartment.
I I
I I
I
NSTNST
NSTNST
NST
ALLINGALLING
ALLINGALLING
ALLING
THETHE
THETHE
THE
CC
CC
C
OMPONENTSOMPONENTS
OMPONENTSOMPONENTS
OMPONENTS
TT
TT
T
RANSCEIVERRANSCEIVER
RANSCEIVERRANSCEIVER
RANSCEIVER
M M
M M
M
ODULEODULE
ODULEODULE
ODULE
The Transceiver Module receives radio
frequency (RF) commands from remotes
to operate a lamp or appliance plugged
into it. The Transceiver Module also
passes on commands over your house
wiring to control other X10 Modules.
Note that unlike the Lamp Module you
cannot dim and brighten a lamp
connected to the Transceiver Module.
You should locate the Transceiver
Module centrally in the home for
maximum range when controlled by the
X10 Learning SuperRemote.
2.2.
2.2.
2. Plug a lamp or
appliance into the
Transceiver
Module.
3.3.
3.3.
3. Plug the Transceiver
Module into a
convenient AC
outlet. Fully extend
the antenna.
LL
LL
L
AMPAMP
AMPAMP
AMP
M M
M M
M
ODULEODULE
ODULEODULE
ODULE
The Lamp Module may be used to
control any incandescent lamp rated up
to 300W. It is not suitable for other types
of lamp such as fluorescent or energy
saving lamps, or lamps which include a
dimmer control.
Caution: Do not connect an appliance
such as a coffee pot or heater to the
Lamp Module. It may damage the
module and the appliance and could
cause a fire hazard.
1.1.
1.1.
1. Set the House Code
to ‘A’ .