Xantech D5KP User Manual

- 16 -
D5KP Speaker Connections
The D5RH and D5SH, D5SH4 routes digital audio to connected D5KP Amplifier Keypad where the
audio is then amplified and sent to in-room speakers.
WARNING!: The D5KP’s amplifier is capable of powering a single pair of 8-6 Ohm speakers.
DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more than one speaker to either speaker
connector of the D5KP. In doing this, damage to the D5KP may occur and will void the products warranty.
To connect speakers to D5KP Amplifier Keypad:
1 Ensure that system power is OFF!
2 Remove the SPEAKER CONNECTOR from the D5KP Amplifier Keypad
3 Strip speaker wire back 1/4"
4 Loosen speaker terminal screws on the speaker connectors
5 Insert speaker wires into terminals making sure to maintain +/- polarity
6 Tighten screws on speaker terminals
7 Re-connect the terminal strip to the SPEAKER CONNECTOR on the D5KP Amplifier Keypad
8 Connect speaker wires to the room speakers maintaining correct polarity
Figure 3.5: Speaker Connections

Xantech D5KP Specifications

General

Brand	Xantech
Model	D5KP
Category	Keypad
Language	English