Customer Release Notes
Fiery EXP4110 version 1.0
Part Number: 45051581
23 September 2005
Copyright 2005 © Electronics for Imaging, Inc.
This document contains information about the Fiery EXP4110 version 1.0. Before using
the Fiery EXP4110 with version 1.0, make copies of these
Customer Release Notes
and the
Quick Connect Guide
and distribute them to all users.
N
OTE
:
This document uses the term “Fiery EXP4110” to refer to the Fiery EXP4110.
The term “printer” is used to refer to the Xerox 4110 printer.
Before printing to the Fiery EXP4110, make sure system software version 1.0 is installed
on the Fiery EXP4110. To determine this, print a copy of the Configuration page.
T
O
PRINT
THE
C
ONFIGURATION
PAGE
FROM
C
OMMAND
W
ORK
S
TATION
1 In Command WorkStation, choose Print Pages from the Server menu.
2 Click Configuration.
3 Click Print.
T
O
PRINT
THE
C
ONFIGURATION
PAGE
FROM
THE
F
IERY
EXP4110 C
ONTROL
P
ANEL
1 Make sure the information screen on the Fiery EXP4110 Control Panel reads Idle.
If Printing or RIPping appears, the Fiery EXP4110 is processing. You must wait until
the system finishes and reaches the Idle state.
2At the Fiery EXP4110 Control Panel, press the Menu button to access the Functions menu.
3 Select Print Pages.
4 Choose Configuration.
You must also install user software version 1.0 on client computers. For instructions,
see
Printing from Windows
and
Printing from Mac OS
.
System
Font archiving
You cannot archive fonts using the Fiery EXP4110 Control Panel. A disk error occurs, and
the fonts are not backed up. As a workaround, use Command WorkStation to archive fonts.
Trying to reconnect message
If the message “Trying to connect” displays on the Fiery EXP4110 Control Panel, shut down
the Fiery EXP41100 and the printer, wait 10 seconds, and then turn both devices back on.
Recycling power on the printer
Any time you recycle power on the printer, you must also recycle power on the
Fiery EXP4110.
To Next Page
Need help?
General