Xerox 8264E User Maintenance and Cleaning Guide 8
6. Close the maintenance cover on the right front of the printer firmly until it is locked.
7. Press the [Enter] key.
a. The print head returns to its original position.
b. The cleaning wiper returns to its original position.
c. "CR Mainte.: Start" displays in the control panel.
8. Press the [Cancel] key several times. "Ready to Print" displays in the control panel.
Cleaning of the cleaning wiper is complete.
Cleaning Around the Cap
This section describes how to clean around the cap.
CAUTION:
Use the gloves included in the cleaning kit to prevent ink and cleaning solvent
from getting on your hands. Do not touch the rubber cap without gloves. Oil from
your hands may prevent the cap from sealing properly.
1. Using either a foam swab or a lint free cloth soaked in Eco-cleaning solution or
Isopropyl Alcohol, wipe around the edges of the rubber cap. This ensures a good seal
is maintained during the head cleaning process.
To Next Page
Loading...
Need help?
General
