Operating the Xerox Production Media Cart (Nuvera)
20 Xerox Nuvera, iGen Production System Production Media Cart
Production Media Cart User Guide
3. Gently lift up on the paper stack clamp near the clamp post, rotate it to one side, and rest it
in the locator on the clamp post.
4. Turn the stock transport handle approximately 15 rotations clockwise to transfer the paper
stack onto the work table.
Note
When transporting to a flat work table, the paper stack may shift and lose stack quality.
Offloading the Stack to a Pallet
This procedure assumes pick up from the XPS low position (210 mm) and the paper stack will be
delivered to either a tined or smooth surface.
1. Press the elevation button to set the media table height until it exceeds the height of the
pallet enough for the bottom of the paper stack to clear it.
2. Lock the casters.
3. Turn the stock transport handle approximately 15 rotations clockwise to transfer the paper
stack onto the pallet
To Next Page
Loading...
Need help?
General
