Installation WorkCentre
®
7200 Series
Customer Expectation and Installation Guide 16
4 Installation
Roles and Responsibilities
This section is key to clearly state Xerox and the customer roles and responsibilities and necessary actions.
Responsibility Matrix
Ensure adequate space and power to configure the WorkCentre 7220/7225
Unpack system / components
Connect all System Components prior to powering up the system
Ensure network configuration
Confirm network integrity
Acquire and install client software including print drivers
Configure Workflow Scanning
Run initial software diagnostics when directed
Monitor and adjust as required
Load any additional fonts
Procure BNC transceiver for network connection (if needed)
Order and replace Kits (Drum cartridges, Second Bias Transfer Roll, transfer belt
cleaner, and Waste Toner Cartridge, etc.) as needed.
Provide Help Line support
Primary customer WorkCentre 7220/7225 applications:
_________________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________________
Special considerations or performance limitations identified by Xerox and agreed to by the customer:
_________________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________________
To Next Page
Loading...
Need help?
General
