31
32
Charging
Note:
• Fully charge the vacuum cleaner before using it for the rst time. This will take
about 4 hours.
• Vacuum cleaner cannot be used while charging.
• Vacuuming at turbo mode for a prolonged period will cause the battery to heat
up, which increases charging time. Allow the vacuum cleaner to cool down for 30
minutes before charging it.
Battery Status Indicator
Note:
Once the vacuum cleaner is fully charged, the indicator will turn o after 5 minutes,
and the vacuum cleaner will enter the energy-saving mode.
Off
Blinking
On
Low battery
Half battery
Nearly full
Fully charged
How to Use
Function Introduction of Display Screen
Electronic Lock / Reset Filter
·Click to switch to Working Mode
·Press and hold for 1.5 seconds to enter the
lter reset interface
Battery level monitor ring
·Blue: Battery level is more than 20%
·Red: Battery level is less than 20%
Gear switch / Language setup
·Click to switch to Eco Mode, Med Mode and
Turbo Mode
·Press and hold for 3 seconds to enter the
language setting interface
Note: If you need to pay attention to any abnormality during the use of the product,
the screen will push a prompt message. You should follow the instructions on the
screen to keep the performance normal.
Language Setup
You may set the display prompt language (Simplied English is the default when you
start the machine) by the following methods as you need.
Note: If there is no operation for more than 5 seconds, it will automatically exit from
the language setting interface, and the display information will be o.
a.Press and hold for 3 seconds to enter the
language selection interface
b.Click to scroll through the language list, and
select the appropriate language
c.Press and hold for 3 seconds to save your
setting setting.
To Next Page
Loading...
Need help?
General
