5
How to Install
Removing the Baery
Hold the vacuum cleaner in one hand and grasp the baery in the other
hand, then press the baery release buon and pull the vacuum cleaner in
the direction shown to separate it from the baery.
Installing the Baery
Slide the vacuum cleaner along the baery track until it clicks into place.
Note: Aer installing the baery, press the power buon to turn on the vacuum cleaner.
Installing the 2-in-1 Charging & Storage Mount
• The 2-in-1 charging & storage mount should be installed in a cool and dry
place with an electrical outlet nearby. Prior to installing, ensure that there
are not any wires or pipes in the wall directly behind where the mount will be
installed.
• The boom of the 2-in-1 charging & storage mount should be at least 115 cm
from the ground.
• Select a suitable installation place and mark the positions of the mounting
holes on the wall.
• Use a power drill with an 8 mm drill bit to drill a hole approximately 40 mm
deep in each marked position, then insert a wall plug into each hole.
• Align the mounting holes on the 2-in-1 charging & storage mount to the holes
on the wall, then aach the mount to the wall using the included screws.
115 cm
Click into Place
To Next Page
Loading...
Need help?
General
