06
RF Exposure Information (SAR)
FCC Note
Important Safety Information
Temperature: 0 °C - 40 °C
Install the adapter near the device in an easily accessible position.
E-label
SAR 10g limit: 2.0W/Kg, SAR Value: Head: 0.749 W/Kg,
Body: 1.585 W/Kg (5mm distance).
SAR 1g limit: 1.6W/Kg, SAR Value: Head: 1.15 W/Kg,
Body-worn: 1.18 W/Kg (10mm distance).
Hotspot: 1.18 W/Kg (10mm distance).
Model: M1808D2TG
1808 indicate the date of putting the product on the market is 201808
This device has an electronic label for certification information.
To access it , please select Settings> About Phone > Certification or select Settings, then type
"Certification" into the search bar.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device meets the government’s requirements for exposure to radio waves. This device is
designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF)
energy. The exposure standard for wireless device employs a unit of measurement known as the
Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/Kg. For body worn operation, this device has been tested and
meets the FCC RF exposure guidelines for use with an accessory that contains no metal and be
positioned a minimum of 1.0 cm from the body. Use of other accessories may not ensure
compliance with FCC RF exposure guidelines. If you do not use a body-worn accessory and are
not holding the device at the ear, position the handset a minimum of 1.0 cm from your body when
the device is switched on.
This mobile phone has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiated radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
