Reset Bluetooth
Make sure the scooter is turned on. Press the accelerator and simultaneously press the power button 5 times to reset. When the
scooter beeps, it has been reset successfully.
Restore Factory Settings
Make sure the scooter is turned on. Squeeze the brake lever, and simultaneously press and hold the accelerator and the power button for
7 seconds. When you hear a beep, the scooter has been restored to factory settings. This operation will completely delete the data
stored in the scooter, please proceed with caution.
Note: The scooter cannot be restored to factory settings during riding or when locked.
1
Wear a helmet, elbow pads and knee pads before riding.
Note: Check the tire pressure before riding. The recommended tire pressure is 40–45 psi.
How to Ride
Before Riding
2
Starting & Accelerating
Step on the deck with one foot, and slowly kicks off the other on the ground.
To Next Page
Loading...
Need help?
General