12
Resume Cleanup
If the robot vacuum starts running low on battery during a cleaning task, it will
automatically return to the charging dock to recharge, then resume cleanup
where it left off after being charged sufficiently.
Note:
If the sleep time exceeds 12 hours, the robot vacuum will be turned off automatically.
Sleep Mode
The robot vacuum will automatically enter sleep mode after it is paused for 10
minutes, and its indicator will go out. To wake it up, press any button on the
robot vacuum.
Pause
Note:
Do not pick up or move the robot vacuum while it is paused, so as to avoid navigation
errors that could prevent the robot vacuum from returning to the charging dock or cause the loss
of map.
While the robot vacuum is running, press any button on the robot vacuum to
pause it, and then press the button to resume the cleaning. Pressing the
button will end the current cleaning task and send the robot vacuum back to
the charging dock.
Update the Firmware
You can update the firmware via the app. Before updating, make sure the robot
vacuum is on the charging dock and has at least 15% battery left.
Restore Factory Settings
If the robot vacuum does not function properly after being restarted, you can
use a pin to press the reset button until you hear a voice to indicate that the
robot vacuum is restoring factory settings. This will reset the robot vacuum to its
original factory settings.
Restart the Robot Vacuum
If the robot vacuum stops responding or cannot be turned off, press and hold
the button for 15 seconds to forcefully turn it off. Then press and hold the
button for 3 seconds to turn the robot vacuum on.
To Next Page
Loading...
Need help?
General
