7
8
Auto-empty Station
Cover
Front View
Back View
Bottom View
Auto-empty Vent
Power Port
On/Off Switch
Cable Grooves
Air Duct Cover
Indicator
·
White: Powered on
·
Blinking orange: Error
Signaling Area
Charging Contacts
How to Install
Remove Protective Coverings
Install the Side Brush
Before using the robot vacuum, remove the protective strips from both sides.
Install the side brush onto the clip on the bottom of the robot vacuum.
Connect to An Electrical Outlet
Place the Robot Vacuum
Place the auto-empty station near an electrical outlet in an area with a good
Wi-Fi signal. Then connect the auto-empty station to power, and turn it on.
Manually place the robot vacuum onto the auto-empty station, and the robot
vacuum will automatically turn on and start charging. When fully charged, the
indicators on the robot vacuum and the station will remain white for 10 minutes
and then go out. Fully charge the robot vacuum when using it for the first time.
Turn on the auto-empty station
> 0.5 m
> 0.5 m
> 1.5 m
Side Brush Clip
Note: Make sure the charging contacts on the robot vacuum and the station are fully aligned.
To Next Page
Loading...
Need help?
General
