Xilinx Zynq-7000 ZC702 User Manual

3
STEP 7: Set Up Terminal Emulator: Serial Setup
Select the same COM port assigned in Step 5 and set
the Baud rate to 115200, the Data to 8 bit, the Parity
to none, Stop to 1 bit, and Flow control to none. Click
OK to save the settings.
X-Ref Targ et - Figure 1-5
STEP 8: Initialize Configuration
Press SW1 (POR_B) to reinitialize the configuration for
the ZC702 board.
STEP 9: Terminal Display
After the ZC702 board is configured
in Step 8, text appears in the
terminal emulator window. Type the
number or letter associated with a
listed option to run a test
application. For example, type 2 to
run the LED Test application.
Note: DIP switches SW15-1 and
SW15-2 are tied in parallel to
pushbuttons SW13 and SW14,
respectively. For SWITCH Test 5,
either use DIP switches SW15-1
and SW15-2, or keep SW15-1 and
SW15-2 OFF and use pushbuttons
13 and 14.
ON
OFF

Xilinx Zynq-7000 ZC702 Specifications

General

Brand	Xilinx
Model	Zynq-7000 ZC702
Category	Motherboard
Language	English