Oven Initial Start-up Checklist - Remove & Return to XLT
Step 3: Place all control boxes in service position and adjust high bias gas pressure per
Parts & Service Manual. Start each oven and complete form below.
Customer Signature: Date:
Step 4: Document the dynamic pressure with all the gas appliances running.
Oven #3 Verify Existing Serial # N/A
Serial #: __________________________________
Fingers in proper location:
Remove finger shipping clips:
Oven #1 Verify Existing Serial # N/A
Serial #: __________________________________
Fingers in proper location:
Remove finger shipping clips:
Oven #2 Verify Existing Serial # N/A
Serial #: __________________________________
Fingers in proper location:
Remove finger shipping clips:
Step 2: Place 1 control box in service position. Hook manometer to top port on gas valve
and document incoming gas pressure. Refer to the Parts & Service Manual for Oven Service
Procedures.
Inlet Pressures: Static Pressure: _________ Is W C within 6-14” WC for Natural Gas or 11-14” WC for LPG.
Yes No, contact store owner to adjust. _____Initial
NOTE: Peel all PVC during installation (page 7).
Take off front panel and remove finger clips (steps 1-3, page 29).
Check for proper installation and placement of return air/end loss plates (step 6, page 42).
Right Burner:
High Bias: _______________ Shutter Setting:________
Left Burner:
High Bias: _______________ Shutter Setting:________
Right Burner:
High Bias: _______________ Shutter Setting:________
Left Burner:
High Bias: _______________ Shutter Setting:________
Right Burner:
High Bias: _______________ Shutter Setting:________
Left Burner:
High Bias: _______________ Shutter Setting:________
Installation & Operation Manual presented to store operator: Yes No
Customer or store operator shown how to disassemble and clean ovens : Yes No
All oven features explained: Yes No
Ovens ran for 30 min: Yes No
Air-born contaminates: Flour Cornmeal Grease Other _________________________________
On-Site food prep: Yes No Test cook performed: Yes No
Product: _____________________________________________
Oven #4 Verify Existing Serial # N/A
Serial #: __________________________________
Fingers in proper location:
Remove finger shipping clips:
Right Burner:
High Bias: _______________ Shutter Setting:________
Left Burner:
High Bias: _______________ Shutter Setting:________
Inlet Pressures: Dynamic Pressure: _______ Is WC within 6-14” WC for Natural Gas or 11-14” WC for LPG.
Yes No, contact store owner to adjust. ____Initial
To Next Page
Loading...
Need help?
General