12
REAR SUSPENSION
TECH TIP
901303
SB M3x3
903310
SFH M3x10
940508
BB 5x8x2.5
981208
P 2x8
902308
SH M3x8
901312
SB M3x12
➊
➋
➌
➌
➍
➎
41.5mm
Follow the TECH TIP below to install the pivot balls
➊➋
➌➍
Follow this tech tip to install pivot balls into ball
joints.
Parts Needed:
• M3 x 16 SH screw
• M3 shim
Note that the composite ball joints have two
sides, noticeable around the pivot ball hole:
one side has a shiny fi nish, the other side has
a regular fi nish.
Install pivot ball into ball joint from the
SHINY side
Tighten screw until pivot ball snaps into ball joint
Remove screw and shim
SHINY
FINISH SIDE
Ensure pivot ball moves freely in
ball joint
SHINY
FINISH SIDE
Pin must protrude equally on
both sides of camshaft
NOTE THE ANGLE DIFFERENCE
BETWEEN THE BALL JOINTS
Use ball joints with
NO DOT
➊
➋
To Next Page
Loading...
Need help?
General
