13
REAR ANTI-ROLL BAR
ADJUSTMENT
REAR SUSPENSION
901303
SB M3x3
902308
SH M3x8
901305
SB M3x5
903310
SFH M3x10
Do not fully tighten the setscrew; the joint
must fi t over the anti-roll bar wire
➊
➋
➋
➌
➌
➍
➍
DETAIL
Pivot balls must move freely.
During initial assembly, tighten each
aluminum hex nut until the pivot ball
starts to bind, then loosen slightly.
Verify that the pivot balls move freely.
Tighten aluminum hex
nuts using HUDY
tool #107581
Wire should be fl ush
with end of pivot ball
Only tighten setscrew enough to
remove excessive free play; anti-
roll bar must still move freely
DETAIL
DETAIL
NOTE
ORIENTATION
NOTE
ORIENTATION
➎
To Next Page
Loading...
Need help?
General
