13
ROLL CENTER
ADJUSTMENT
2. REAR SUSPENSION
902308
SH M3x8
902308
SH M3x8
BEARING OIL
BEARING OIL
NOTE ORIENTATION
NOTE ORIENTATION
Both bushings must be in same position
#335451
HIGH-PERFORMANCE KEVLAR® DRIVE
BELT REAR 5.5x177mm - V2
941016
BB 10x16x4
TO LOOSEN REAR BELT: Rotate both rear nylon hubs in arrow direction A
REAR BELT TENSION ADJUSTMENT
L=R
BA
TO TIGHTEN REAR BELT: Rotate both rear nylon hubs in arrow direction B
INITIAL POSITION
DETAIL
NOTE ORIENTATION
Both bushings must be in same position
LEFT REAR ARM
RIGHT REAR ARM
-0.5mm
-0.5mm
Use (-0.5mm) suspension
holders for initial assembly.
REAR ROLL CENTER INSERT POSITIONS
-1.5mm -0.5mm +0.5mm +1.5mm
INITIAL SETTING
NOTE ORIENTATION
2x
It is extremely important that the arms
move freely on the pivot pins. If they do
not, use the #107633 HUDY Arm Reamer
to slightly resize the holes in the arms.
3x6x2mm
903306
SFH M3x6
DETAIL
Hole is from outside
NOTE ORIENTATION
303123-O
SHIM 3x6x2
To Next Page
Loading...
Need help?
General
