To Next PageTo Next PageTo Previous PageTo Previous Page
Need help?Do you have a question about the Xray RX8 and is the answer not in the manual?
General| Battery Type | LiPo |
|---|---|
| Drive Type | 4WD |
| Scale | 1:8 |
| Class | Buggy |
| Power | Electric |
| Battery Voltage | 14.8V |
| Chassis Material | Aluminum |
| Radio System | Not included |
| Suspension | Independent |
Guidelines and prerequisites for building and operating the RC model.
Contact information and resources for XRAY customer assistance.
Essential safety warnings and guidelines for operating the RC model.
Key considerations and advice for assembly and operation.
Crucial safety and operational notes for electrical and nitro fuel components.
Practical advice for building and warranty information for the RC model.
Legal disclaimers and limitations of XRAY's liability.
Explanation of symbols used throughout the instruction manual.
List of parts included and not included in the model kit.
List of specific tools and additional RC equipment necessary for operation.
Guidance on initial adjustment settings for suspension components.
Procedure for adjusting the tension of the rear drive belt.
Instructions for installing and adjusting the rear anti-roll bars.
Assembly and mounting instructions for the rear body post.
Details on selecting and installing gears for the transmission.
Specific assembly steps for the two-speed transmission mechanism.
Installation and adjustment of the front anti-roll bar.
Procedure for adjusting the tension of the front drive belt.
Instructions for installing different types of front anti-roll bars.
Guide on how to adjust the front belt tensioner.
Guide to adjusting the Ackermann steering geometry for performance.
Adjustment procedure for the front wheel toe-in angle.
Details on selecting and installing pinion gears for the engine.
Specific advice for improving engine power and clutch shoe maintenance.
Guides on how to adjust the clutch gap and endplay.
Selection and installation of front and rear shock springs.
Procedure for filling shock absorbers with oil and bleeding air.
Steps for assembling shocks and adjusting rebound and length.
Adjusting throttle and brake linkages for proper control.
