13
TOE-IN
ANTI-SQUAT
ROLL CENTER DOWNSTOP
WHEELBASE
TRACK WIDTH
909395
SS 3.5x45
909372
SS 3.5x22
901408
SB M4x8
353371
SHIM 4x10x2
HARD / X-HARD / GRAPHITE
SUSPENSION ARMS
(HUDY #107634)
ARM REAMER
If the suspension arm does not move
freely use a HUDY Arm Reamer to
resize the holes of the arms.
➊
➊
➋
➌
➌
➍
➍
➎
2mm
4x8mm
RR
RF
All possible mounting
alternatives of eccentric bushings
INITIAL SETTING
RF
INITIAL SETTING
RR
Check for free movement
DETAIL
DETAIL
ECCENTRIC BUSHINGS HAVE TWO DIFFERENT OFFSETS FROM THE CENTER.
Middle position = 0.5 mm or 0.5° from center
Outer position = 1mm or 1° from center
The XRAY rear alu lower suspension holders provide even greater range of adjustment for the rear suspension. Using different combinations of eccentric bushings, fine adjustment of rear anti-squat, rear
toe-in, rear roll center, and rear track-width can be obtained. For more information about the influence of rear anti-squat, rear toe-in, rear roll center and rear track width on car handling, please refer to
HUDY Off-Road Set-up Book (#209099).
The tables describe the amounts of rear anti-squat, rear toe-in, rear track-width change depending
on the combinations of eccentric bushings used with 0 and 1mm, 1° offset. The 0.5mm, 0.5° represents
the half change.
Anti-Squat Example:
0(RR) - 0 (RF) = 3°
0(RR) - 0.5 (RF) = 3.5°
0(RR) - 1 (RF) = 4°
ANTI-SQUAT ROLL CENTER TRACK-WIDTH TOE-IN
RR RR RR RRRF RF RF RF(°) (mm) (mm) (°)
=3°
=4°
=2°
=4°
=3°
=5°
=2°
=3°
=1°
= 3°
= 3.5°
= 4°
=0
mm
=1mm
=-1mm
=308
=306
=310
=3°
=4°
=2°
=2°
=3°
=1°
=4°
=5°
=3°
3.5x45mm
3.5x22mm
BOOK
SET-UP
0.5º1º
0.5º1º
2.0mm
DOWNSTOP SETTING
DETAIL
2.0mm Allen
#902407
Downstop screw
for fine tuning.
NOTE
ORIENTATION
NOTE
ORIENTATION
MEDIUM
SUSPENSION ARMS
RF
RR
Do not use INNER positions.
0.5º
0.5º
1º
1º
RF
RR
All positions are available.
0.5º
0.5º
1º
1º
3. REAR SUSPENSION
REAR SUSPENSION ARMS
#353115 MEDIUM OPTION
#353116 HARD OPTION
#353116-XH X-HARD INCLUDED
#353116-G GRAPHITE OPTION
XB8XB8E
To Next Page
Loading...
Need help?
General
