Xray XB8 User Manual

11
2. FRONT TRANSMISSION
901504
SB M5x4
LOWER CENTER
BALL-BEARING HUB
POSITIONS
UPPER
INITIAL SETTING
DETAIL
➊
➌
FRONT DIFF 7.000cSt
Graphite Grease
(HUDY #106210)
Push joint against gear to remove gap.
Tighten setscrew onto gear flat spot.
DETAIL
Follow the TECH TIP on page 5
for drive shaft pin servicing.
908312
SCH M3x12
908316
SCH M3x16
STEP DETAIL
➌
➋
NOTE ORIENTATION
➌
During assembly, there is no need to check gear mesh or diff play. In particular,
DO NOT check gear mesh and diff play when the differential is installed only in
the gear box without the suspension holders and without being mounted to the
chassis. All parts have specifically designed play, and only when the car is fully
assembled will it have the proper amount of play where necessary. Only once
you build the entire car, then you can check for free movement of all rotational
parts and drivetrain as well a free non-binding operation of suspension parts.
LOWER
Bevel & Differential
LOWER LOWER
DETAIL
DETAIL STEP
DETAIL STEP
GEAR
RATIO
Internal Gear Ratio = 3.54
(Bevel) (Pinion) (IGR)
46
:
13 = 3.54
TIGHTEN
3x12mm SCREWS
FIRST
TIGHTEN
3x16mm SCREWS
SECOND
Tighten 3x12mm screws first, then tighten 3x16 screws.

Xray XB8 Specifications

General

Brand	Xray
Model	XB8
Category	Motorized Toy Car
Language	English