Xterra FS2.5 User Manual

FS2.5 Elliptical
5
1. Locate the Console Mast (9) and slide on the Console Mast Cover (82).
Make sure the cover is facing the correct direction, as shown below,
before sliding onto mast. Install the wiring harness (94) into the bottom
of the mast and out the top. Be careful when installing the console mast
to the mainframe so as not to pinch or cut the wiring harness; damage to
the electronics may occur.
2. Install the console mast on the mainframe with ve Button Head Socket
Bolts (43), four Flat Washers (44) and one Curved Washer (45). Tighten
using the M5 Allen Wrench (68). Snap the Console Mast Cover (82) in
place against the plastic covers below.
3. Route the hand pulse wires (96) from the stationary handle bars (10, 11)
through the Console Mast (9) as shown below. Attach the handles to the
Console Mast (9) with four Button Head Socket Bolts (43). Use the M5
Allen Wrench (68) to tighten.
4. Connect the cables (94 & 96) to the Console (58) and install console
onto the Mast (9) with four Phillips head screws (53). Tighten using the
Phillips Head Screw Driver (68).
5. Secure the Front Stabilizer (12) and Rear Stabilizer (13) with four Button
Head Socket Bolts (43), four Split Washers (46) and four Flat Washers
(44). Tighten using the M5 Allen Wrench (68).
FS2.5 Assembly Instructions
Hardware Step 1
Stabilizers, Console Mast & Console
#43. 5/16” x 3/4”
Button Head Socket
Bolt (13 pcs)
#44. 5/16” Flat
Washer (8 pcs)
#45. 5/16”
Curved Washer
(1 pc)
#46. 5/16”
Split Washer (4 pcs)
#53. M5 x 12mm
Phillips Head Screw
(4 pcs)
1

Xterra FS2.5 Specifications

General

Brand	Xterra
Model	FS2.5
Category	Elliptical Trainer
Language	English