X-Series Service Tool
18
3.2 USB data wire upgrade
The product supports the upgrading of computers through USB connection, and
downloads the upgrade program to upgrade the equipment according to the prompt
information.
The upgrade method is as follows.
1. Log on the Xtool official website: www.xtooltech.com, Select ’Download
Upgrade Tool’ on the page of ‘Service&Support’ , and install the upgrade tool.
2. Open the upgrade software, enter the product serial number and activation code
to log in the software.
3. Connect the X300P/X100Pro2 handheld device to the computer through the USB
cable.
4. When the X300P/X100Pro2 handheld device is turned on, the computer software
will automatically connect the device and log in.
5. Select installation items for computer software to upgrade procedures.
6. Disconnect the USB cable and restart the X300P/X100Pro2 handheld device to
start using the upgrade software.
To Next Page
Loading...
Need help?
General
