4
CARBON MONOXIDE PRECAUTIONS
FIRE AND EXPLOSION PRECAUTIONS
CHEMICAL PRECAUTIONS
1. Fill the fuel tank: To obtain the proper 25:1 fuel mix, combine 25 parts
unleaded gasoline (89+ octane) with 1 part 2-cycle oil in the provide Fuel
Mix Container (36a). Cover and shake to thoroughly mix before each
fueling.
PRE-START INSTRUCTIONS
NOTE: Mix only enough fuel for a few days work. The maximum storage
time of mixed fuel is three months.
2. Once the proper fuel mix is obtained, removed the Fuel Cap (93). Fill the Fuel Tank (89) approximately ¾
full with the fuel mix. Then replace the Fuel Cap. See Figure B.
WARNING: Do not attempt to ll the Fuel Tank (89) when the engine is running or hot to the touch.
IMPORTANT: Your warranty is voided if you do not operate the Auger Drill with the proper amount of SAE
80-90 gear oil in its Gearbox (8a). DO NOT run the Auger Drill with low or no gear oil. Running the unit in
this manner can permanently damage the unit.
FILL THE GEARBOX
1. Remove the Oil Fill Plug (20a) and carefully ll (approximately 8-1/2 ounces) the Gearbox (8a) then
replace the Oil Fill Plug and tighten securely. See Figure B.
NOTE: DO NOT use dirty, used or otherwise contaminated Gear Oil. Damage may occur to the internal
mechanisms of the Gearbox.
OPERATION
To Next Page
Loading...
Need help?
General