6.Specification
P switch
Ground wire
Positive
485 communication
Flashing signal
High beam indication
Right turning indication
Left turning indication
Front left turning light
Front right turning light
Rear left turning light
Rear right turning light
Dimmer switch
Blue Pink White
Headlight
High beam
Low beam
Taillight
Controller
48V
strong current
Throttle
Throttle signal
Signal wire
Phase wire C
Phase wire B
Phase wire A
Charging port
48V Lithium battery
Air switch 40A
GPS
Converter
Alarm
Grey
Red
black
Red
black
Green yellow
Front brake switch
Rear brake switch
Left button switch
Brown Pink
Light
blue
Orange
Antenna
Alarm horn
Turning
light switch
485
communication
Speedometer indication
Left turning light Right turning light Headlight Brake light
Horn
Headlight switch
Wheel movement
detection
48V
weak current
Over speed alarm
Brake power off
Alarm signal
47 48
Trouble shooting list
Electric schematic diagram
Failure phenomena
The scooter is not powered on
Turn on the power supply, the
speedometer normally display,
and the speed regulation
malfunction.
The cruising range is insufficient
after one charge.
The charger does not charge.
Other failures
Failure reason and troubleshooting methods
●Power lock failure: Repair or replace the power
lock or plug-in.
●Fuse open: Find out the reason and replace the fuse.
●Poor circuit contact: Retighten the power lead plug.
●Battery voltage too low: Charge enough electricity.
●Power failure brake lever malfunction: Repair or
replace the power failure brake lever.
●Throttle failure: Replace the throttle.
●Controller or motor failure: Contact authorized
service station for repair or replacement.
●Insufficient tire pressure: Tyre inflation to standard
atmospheric pressure.
●Insufficient charge: Check the charger and fill up
the battery.
●Battery aging: Contact authorized service station
to replace the battery.
●Braking abnormally: Adjust the brake to make the
front and rear wheels rotate smoothly.
●Mechanical transmission obstruction: Regularly
lubricate the rotating transmission components.
●Riding environment: There are a lot of roads, strong
headwinds, frequent brake starts, heavy loads, etc.
It is suggested to reduce the number of brake
starts and reduce the load.
●Poor contact: Reconnect the charger
input/output plug.
●Charger damaged: Contact the authorized
service station to replace the charger.
●Battery pack open circuit: Reconnect the battery wire.
●When you encounter a failure that cannot be
automatically discharged or determined through the
above guidance, or when you encounter damage to the
motor, controller, charger and battery pack, please
contact the resident authorized service station in time
and do not open the above components without
authorization, otherwise you will lose the warranty
promise of our company.
To Next Page
Loading...
Need help?
General
