Operation
30
IP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3. Place the throttle grip in the “ ”
(start) position.
4. Pull out / turn the choke knob fully. After
the engine starts, replace / return the
knob to the home position.
IP:
●
It is not necessary to use the choke when
starting a warm engine.
●
If the choke knob is left in the “ ”
(start) position while the engine is running,
the engine will run poorly or stall.
5. Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
6. After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
7. Slowly return the throttle grip to the fully
closed position.
ZMU03803
ZMU02954
ZMU03774
To Next Page
Loading...
Need help?
General
