Maintenance
42
stops.
11. Drain the cooling water completely out
of the motor. Clean the body thoroughly.
12. If the “Fogging Oil” is not available, re-
move the spark plug(s). Pour a tea-
spoonful of clean engine oil into each
cylinder. Crank several times manually.
Replace the spark plug(s).
13. Drain the fuel from the fuel tank.
IP:
Store the fuel tank in a dry, well-ventilated
place, not in direct sunlight.
EMU28402
Lubrication
1. Install the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 47.
2. Change the gear oil. For instructions,
see page 51. Inspect the oil for the pres-
ence of water that indicates a leaky seal.
Seal replacement should be performed
by an authorized Yamaha dealer prior to
use.
3. Grease all grease fittings. For further de-
tails, see page 47.
IP:
For long-term storage, fogging the engine
with oil is recommended. Contact your
Yamaha dealer for information about fogging
oil and procedures for your engine.
EMU28450
Cleaning the outboard motor
After use, wash the exterior of the outboard
motor with fresh water. Flush the cooling
system with fresh water.
IP:
For cooling system flushing instructions, see
page 40.
EMU28460
Checking painted surface of motor
Check the motor for scratches, nicks, or flak-
ing paint. Areas with damaged paint are
more likely to corrode. If necessary, clean
and paint the areas. A touch-up paint is avail-
able from your Yamaha dealer.
EMU37072
Periodic maintenance
WARNING
EWM01981
These procedures require mechanical
skills, tools, and supplies. If you do not
have the proper skills, tools, or supplies
to perform a maintenance procedure,
have a Yamaha dealer or other qualified
mechanic do the work.
The procedures involve disassembling
the motor and exposing dangerous parts.
To reduce the risk of injury from moving,
hot, or electrical parts:
●
Turn off the engine and keep engine
shut-off cord (lanyard) with you when
you perform maintenance unless other-
wise specified.
●
Allow the engine to cool before han-
dling hot parts or fluids.
●
Always completely reassemble the mo-
ZMU02871
To Next Page
Loading...
Need help?
General
