Yamaha 8 User Manual

Operation
33
6. After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
7. Slowly return the throttle grip to the fully
closed position.
T
IP:
●
When the engine is cold, it needs to be
warmed up. For further information, see
page 33.
●
If the engine does not start on the first try,
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and
try again. Also if the engine is warm and
fails to start, open the throttle a same
amount and try to start the engine again. If
the engine still fails to start, see page 55.
EMU36510
Checks after starting engine
EMU36520
Cooling water
Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole shows that the wa-
ter pump is pumping water through the cool-
ing passages. If the cooling passages are
frozen, it may take a while for water to start
flowing out of the pilot hole.
NOTICE
ECM01810
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
Check that no water leaks from the joints be-
tween the exhaust cover, cylinder head, and
body cylinder.
EMU27670
Warming up engine
EMU27683
Choke start models
After starting the engine, allow it to idle for 3
minutes to warm up. Failure to do so will
ZMU02030
ZMU02856

Yamaha 8 Specifications

General

Brand	Yamaha
Model	8
Category	Outboard Motor
Language	English