Operation
34
EMU36970
Stop switches
●
Press the engine stop button and make
sure the engine stops.
●
Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
●
Confirm that the engine cannot be started
with the clip removed from the engine shut-
off switch.
EMU34550
Shifting
WARNING
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
NOTICE
ECM01610
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the en-
gine, shift to neutral, then restart the en-
gine and allow it to warm up.
To shift out of neutral
Move the gear shift lever firmly and crisply for-
ward (for forward gear) or backward (for re-
verse gear). Be sure to check that the tilt lock
lever is in the lock/down position (if equipped)
before operating in reverse.
To shift from in gear (forward/reverse) to neu-
tral
1. Close the throttle so that the engine
slows to idle speed.
2. After the engine is at idle speed in gear
move the gear shift lever firmly and crisp-
ly into the neutral position.
ZMU02030
U63V1EE0.book Page 34 Tuesday, March 3, 2009 10:50 AM
©2019 Yamaha Motor Corporation, U.S.A.
To Next Page
Loading...
Need help?
General
