To Next Page

To Previous Page

Changes in EDIT MODE

Chapter 2 Upgrade Reference

Changes in EDIT MODE

EDIT - COMMAND Key - REVERT ☞ 149

This page now also shows the name of the selected sample or sample bank.

EDIT - COMMAND Key - NORM ☞ 150

This page now also shows the name of the sample selected for normalization.

EDIT - COMMAND Key - RESMPL - TmStrch [Resampling - Time Stretch] ☞ 151

On Version 1, the length was always indicated by address units. On Version 2, you can

also display the length in beats or time units by setting the EndType parameter (in the

EDIT | TRIM/LOOP Config page) to beats or time, respectively.

Unlike Version 1, Version 2 will now retain the loop-start and loop-end addresses after

resampling.

EDIT - COMMAND Key - REVERS [Reverse] ☞ 157

This page now also shows the name of the sample selected for reversal.

EDIT - COMMAND Key - LOOPXFD [Loop Crossfade] ☞ 158

• The Area parameter was moved from Knob 3 to Knob 4.

• Knob 3 is now used to select the crossfade curve. For information about curve set-

tings, see the Owner’s Manual, page 156.

Yamaha A3000 Upgrade Guide

Other manuals for Yamaha A3000