REAR PANEL
Remote Control Connector
Permits remote access to SPX90 effect programs.
The optional remote control unit, model RC7, per-
mits direct access to programs 1 through 7 and 31
through 37, while all other preset programs may be
accessed sequentially.
This LED lights whenever
a remote control key is
pressed.
Preset keys.
It is possible to call user
programs when this LED
is lighted.
When this key is
pressed, the USER LED
will light and it becomes
possible to select user
programs 31 through 37.
USER LED OFF
— Preset programs —
1. REV 1 HALL
2. REV 2 ROOM
USER LED ON
— User programs —
31.
User program
3 2 . User program
33.
User program
34. User program
3. REV 2 VOCAL
4. REV 4 PLATE
5. EARLY REFLECTION 1
6. EARLY REFLECTION 2
7. DELAY L, R
30. PARAMETRIC EQ
(Programs 8 through 30
selected sequentially by
pressing OTHERS/ -37-
key)
35.
User program
36.
User program
37.
User program
MIDI THRU Connector
Re-transmits MIDI data received at the MIDI IN con-
nector to subsequent MIDI instruments.
MIDI IN Connector
Permits SPX90 effect programs to be automatical-
ly selected via a MIDI signal. This connector must
be connected to the MIDI OUT connector of the
transmitting MIDI instrument via a standard MIDI
cable.
Output Level Selector (– 20 dB, + 4 dB)
Facilitates SPX90 source/line level (sensitivity)
matching.
Output Jacks (L and R)
These are standard mono 1/4” phone jacks which
deliver the direct and effect signal to subsequent
mixing or amplification equipment. Since the SPX90
offers stereo output, we recommend that the out-
put signal be fed in stereo to a stereo sound system
in order to take full advantage of the superb stereo
effects provided. Output impedance is 600 ohms.
Input Level Selector ( – 20 dB, + 4 dB)
Permits SPX90 source/line level (sensitivity)
matching.
Input jack
This standard unbalanced mono 1/4” phone jack ac-
cepts the input signal to the SPX90. Input im-
pedance is 10 k-ohms.
4
To Next Page
Loading...
Need help?
General
