Operation
25
motor greatly affects the water resistance. If
the mounting height is too high, cavitation
tends to occur, thus reducing the propulsion;
and if the propeller tips cut the air, the engine
speed will rise abnormally and cause the en-
gine to overheat. If the mounting height is too
low, the water resistance will increase and
thereby reduce engine efficiency. Mount the
outboard motor so that the anti-cavitation
plate is in alignment with the bottom of the
boat.
NOTE:
●
The optimum mounting height of the out-
board motor is affected by the boat/motor
combination and the desired use. Test
runs at different heights can help deter-
mine the optimum mounting height. Con-
sult your Yamaha dealer or boat
manufacturer for further information on de-
termining the proper mounting height.
●
For instructions on setting the trim angle of
the outboard motor, see page 34.
EMU27020
Breaking in engine
Your new engine requires a period of break-
in to allow mating surfaces of moving parts to
wear in evenly. Correct break-in will help en-
sure proper performance and longer engine
life.
CAUTION:
ECM00140
●
Failure to follow the break-in procedure
could result in reduced engine life or
even severe engine damage.
●
Premix fuel must be used during break-
in in addition to oil in the oil injection
system.
EMU27060
Gasoline and engine oil mixing chart
(50:1)
CAUTION:
ECM00150
Be sure to mix gasoline and oil complete-
ly, otherwise the engine may be dam-
aged.
EMU30311
Procedure for oil injection models
Run the engine under load (in gear with a
propeller installed) for 10 hours as follows.
1. First 10 minutes:
Run the engine at the lowest possible
speed. A fast idle in neutral is best.
2. Next 50 minutes:
Do not exceed half throttle (approxi-
mately 3000 r/min). Vary engine speed
occasionally. If you have an easy-plan-
ing boat, accelerate at full throttle onto
plane, then immediately reduce the
ZMU01762
1. : Engine oil
2. : Gasoline
To Next Page
Loading...
Need help?
General
