Trouble recovery
96
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.
(3) Connect the other end of the negative (–)
jumper cable to an engine hanger.
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. (See page 27 for information on
starting the engine.)
EJU44050
Replacing the fuses
If a fuse is blown, replace it with the proper
fuse.
To replace a fuse:
(1) Remove the seats and removable water-
tight storage compartment. (See page 43
for seat removal and installation proce-
dures and page 48 for information on the
removable watertight storage compart-
ment.)
1 Positive (+) jumper cable
2 Booster battery
3 Negative (–) jumper cable
4 Engine hanger
1 Good fuse
2 Blown fuse
1 Good fuse
2 Blown fuse
UF4E74E0.book Page 96 Wednesday, July 17, 2019 4:26 PM
To Next Page
Loading...
Need help?
General