EasyManuals Logo
Home>Yamaha>Motorcycle>YZ250F

Yamaha YZ250F User Manual

Yamaha YZ250F
356 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #277 background imageLoading...
Page #277 background image
FUEL TANK
7-2
EAS1SM5308
REMOVING THE FUEL TANK
1. Extract the fuel in the fuel tank through the
fuel tank cap with a pump.
2. Remove:
Fuel hose coupler
EWA23P10 01
WARNING
Cover the fuel hose connection with a cloth
when disconnecting it. This is because re-
sidual pressure in the fuel hose could cause
fuel to spurt out when the hose is removed.
ECA23P1090
NOTICE
Make sure that the fuel hose is disconnect-
ed by hand. Do not forcefully disconnect the
hose with tools.
TIP
To disconnect the fuel hose from the fuel tank,
remove the fuel hose connector holder “a”,
and then slide the fuel hose connector cover.
To remove the fuel hose from the fuel rail,
slide the fuel hose connector cover “1” on the
end of the hose in the direction of the arrow
shown, press the two buttons “2” on the sides
of the connector, and then remove the hose.
Before removing the hose, place a few cloths
in the area under where it will be removed.
To prevent sand, dust, and other foreign ma-
terials from entering the fuel pump, install the
included fuel hose joint cover 1 “3” and the
fuel hose joint cover 2 “4” onto the disconnect-
ed fuel hose and the fuel pump.
3. Remove:
Side cover (left/right)
Seat
Air scoop (left/right)
Fuel tank
TIP
Do not set the fuel tank down on the installation
surface of the fuel pump. Be sure to lean the
fuel tank against a wall or the like.
EAS1SM5309
REMOVING THE FUEL PUMP
1. Remove:
Fuel pump
ECA14720
NOTICE
Do not drop the fuel pump or give it a strong
shock.
EAS1SM5310
CHECKING THE FUEL PUMP BODY
1. Check:
Fuel pump body
Obstructions Clean.
Cracks/damage Replace the fuel pump
assembly.
EAS1SM5311
INSTALLING THE FUEL PUMP
1. Install:
Fuel pump gasket
Fuel pump
Fuel pump bracket
TIP
Take care not to damage the installation sur-
faces of the fuel tank.
Always use a new fuel pump gasket.
Install the lip on the fuel pump gasket upward.
Install the fuel pump as shown in the figure.
Align the projection “a” on the fuel pump with
the slot “b” in the fuel pump bracket.
Tighten the fuel pump bolts in the proper tight-
ening sequence as shown.
a
1
2
Fuel pump bolts
4.0 Nm (0.40 m·kgf, 2.9 ft·lbf)
3
4
New
T
R
.
.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha YZ250F and is the answer not in the manual?

Yamaha YZ250F Specifications

General IconGeneral
BrandYamaha
ModelYZ250F
CategoryMotorcycle
LanguageEnglish

Related product manuals