To Next Page

To Previous Page

- 16 -

WARNING

Improper maintenance and storage of the sweeper may void your warranty.

MAINTENANCE

· After each use clean material out of hopper.

· Rinse/dry inside and outside of the sweeper after each use.

· Remove any material which has wrapped around the brushes.

· Periodically check all fasteners for tightness.

· Twice a year apply a few drops of light multipurpose oil to the brush shaft bearings.

· Annually clean and lightly lubricate all moving parts.

· Every two years remove and clean gears and apply an even coat of light synthetic grease.

· Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.

· Never exceed the hopper load capacity rating it will damage the bag.

· Rinse/dry inside and outside of the sweeper after each use.

· Regularly grease axle and wheel bearing area or when needed.

· Periodically check all fasteners for tightness.

LUBRICATION

The bearings in the sweeper have been pre-lubricated at the factory; however it is recommended that

a few drops of light multipurpose oil should be added to the brush shaft bearings twice a year. Also, the

wheels should be removed too clean gears every two years. After cleaning apply an even coat of light

synthetic grease.

NOTE: To remove wheel, use a screwdriver to pop off hub cap, remove the lock nut and washer.

WHEEL GEARS/PAWL SERVICE

DO NOT remove both wheels at the same time. Remove one wheel at a time to prevent use the

wrong parts for the opposite side (left and right sides are different). When removing gears make

notes on position of all washers and other parts.

Maintenance

and

Storage

YARD Commander SP31128 User Manual

Questions and Answers: