CHECK BEFORE OPERATION
- 7 -
Running the engine with a low oil level can cause engine
damage，so always check the engine oil level before startup.
3) Check fuel
First stop the engine, open the fuel cover, and check oil level., if the oil level is too low, add
the fuel to full, after finishing, screw the fuel cover down.
Refuel in a well-ventilated area before starting the engine. If the engine has been running,
allow it to cool. Refuel carefully to avoid spilling fuel. Don’t add the fuel over the shoulder
of the carburetor when fueling (maximum oil level).
Never refuel the engine inside a building where gasoline fumes may reach flames or
sparks. Keep gasoline away from appliance pilot lights, barbecues, electric appliances,
power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental damage. Wipe up spills
immediately.
Fuel tank volume：1.4 L
Recommended octane rating over 90 unleaded gasoline for unleaded gasoline, can make
carbon deposit muck less and enhance exhaust system service life
Don’t use used and contaminated or gasoline with oil , Avoid the dirt and water entering
into fuel tank.
4)Check the Equipment Powered by This Engine
Review the instructions provided with the equipment powered by this engine for any
precautions and procedures that should be followed before engine startup.
To Next Page
Loading...
Need help?
General
