CHECK BEFORE OPERATION
- 6 -
4. CHECK BEFORE OPERATION
IS YOUR ENGINE READY TO GO?
For your safety, and to maximize the service life of your equipment, it is very important to
take a few moments before you operate the engine to check its condition. Be sure to take
care of any problem you find, or have your servicing dealer correct it, before you operate
the engine.
Improperly maintaining this engine,
or failing to correct a problem
before operation, could cause a
malfunction in which you could be
seriously injured.
Always perform a preoperation
inspection before each operation,
and correct any problem.
Before beginning your preoperation checks, be sure the engine is level and the engine
switch is out off the key hole.
1) Check the General Condition of the Engine
⚫ Look around and underneath the engine for signs of oil or gasoline leaks.
⚫ Remove any excessive dirt or debris, especially around the muffler and recoil starter.
⚫ Look for signs of damage.
⚫ Check that all shields and covers are in place, and all nuts, bolts, and screws are
tightened.
2) Check oil
When stopping the engine at horizontal place, check the oil
1) Take the oil dipstick and clean
2) Insert the oil dipstick in and check the oil lever without screwing down.
3) If the oil is too low, add the recommenced oil in the high safe limits position.
4) After finishing, reassemble and screw the oil dipstick down.
To Next Page
Loading...
Need help?
General
