Improperly maintaining this
engine, or failing to correct a
problem before operation, could cause a malfunction
in which you could be seriously injured.
Always perform a preoperation inspection, and
correct any problem.
Carbon monoxide gas is
toxic. Breathing it can cause
unconsciousness and even kill you.
Avoid any areas or actions that expose you to carbon
monoxide.
WARNING
WARNING
CHECK BEFORE OPERATION
)RU\RXUVDIHW\DQGWRPD[LPL]HWKHVHUYLFHOLIHRI\RXU
equipment, it is very important to take a few moments before you
operate the engine to check its condition. Be sure to take care
RIDQ\SUREOHP\RXĆQGRUKDYH\RXUVHUYLFLQJGHDOHUFRUUHFWLW
before you operate the engine.
Before beginning your preoperation checks, be sure the engine is
level and the engine switch is in the OFF position.
CHECK THE GENERAL CONDITION OF THE ENGINE
Look around and underneath the engine for signs of oil or
gasoline leaks.
Remove any excessive dirt or debris, especially around the
PXIćHUDQGUHFRLOVWDUWHU
Look for signs of damage.
Check that all shields and covers are in place, and all nuts, bolts,
and screws are tightened.
CHECK THE ENGINE
Check the engine oil level. Running the engine with a low oil level
can cause engine damage.
The Oil Alert system (applicable engine types) will automatically
stop the engine before the oil level falls below safe limits.
However, to avoid the inconvenience of an unexpected shutdown,
always check the engine oil level before startup.
Check the air filter. A dirty air filter will restrict air flow to the
carburetor, reducing engine performance.
Check the fuel level. Starting with a full tank will help to eliminate
or reduce operating interruptions for refueling.
CHECK THE EQUIPMENT POWERED BY THIS ENGINE
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should be
followed before engine startup.
IS YOUR ENGINE READY TO GO?
STARTING THE ENGINE
OPERATION
%HIRUHRSHUDWLQJWKHHQJLQHIRUWKHĆUVWWLPHSOHDVHUHYLHZWKH
IMPORTANT SAFETY INFORMATION and the chapter titled
BEFORE OPERATION.
Review the instructions provided with the equipment powered
by this engine for any safety precautions that should be observed
in conjunction with engine startup, shutdown, or operation.
SAFE OPERATING PRECAUTIONS
6
Gasoline Engine
»
Operator’s Manual
Check Before Operation & Operation
|
Starting primer bulb operation is important operation of the
starting engine. For cold starting, slightly press the primer
bulb one to three times in succession and quickly pull the
recoil cable grip. For hot starting, directly pull the starter
cable grip.
Pull the starter grip lightly until resistance is felt, then,
briskly pull to syncline upper 30 degree out.
2.
1.
PRIMER
BULB
To Next Page
Loading...
Need help?
General
