Please note: • Your Yarvik GoTab is a high precision electronic product, do not try to
disassemble the GoTab, as this will void your warranty and may result in
malfunctioning of the device;
• Avoid strong beating of or to the product;
• Avoid using the GoTab in a high or low temperature environment, or in any
environment where the device can get in contact with moisture, dust or
magnetic fields;
• Do not expose the GoTab to strong sunlight for an extended period of time;
• Don’t operate the touch screen of the GoTab with sharp objects, as this may
result in scratching the screen surface;
• Using connected headphones on the GoTab for too long and/or setting the
audio volume up too high when using headphones may cause serious hearing
damage;
• Do not cross the road, drive a motor vehicle or bicycle while using the GoTab
with headphones to avoid traffic accidents;
• Only use permitted batteries, chargers and accessories with your Yarvik
GoTab. The use of any other products with the GoTab can be dangerous and
may violate the warranty regulations;
• Only use a slightly wet cotton cloth to clean the GoTab, and only use water to
wetten the cotton cloth. The GoTab should not be cleaned with any sort of
(glass) cleaning aid.
You may go ahead and use your Yarvik GoTab right out of the box, without charging the battery
first.
It is best for the battery to first run on the charge left in it, and to be fully recharged once it’s
completely drained for the first time.
If the GoTab isn’t switching on right out of the box, the battery is already completely drained and
you should ofcourse recharge it first.
2 GoTab Startup
When you first power on your Yarvik GoTab, you will be presented the startup sequence.
The very first startup may take a while, approximately 2-3 minutes.
After the startup sequence the GoTab has completed starting up and you will be presented the
Android Lock Screen.
To Next Page
Loading...
Need help?
General
