!
Assembly Manual
EN
Thank you for purchasing a Yasuni exhaust.
For the proper operation of your exhaust, please follow the instructions in this manual in detail.
If you have any questions about mounting and/or using your exhaust, please contact your nearest Yasuni distributor or
visit our ofcial website: http://www.yasuni.com
CAUTION
Check that the motorcycle is in a safe position to prevent it from tipping over and causing any kind of damage.
Make sure that the parts you have received are those that appear in the list of parts required to install the exhaust.
The silencer is a product that can reach very high temperatures, so it should not be placed near parts of the vehicle that
are not heat-resistant, such as fuel pipes, brake pipes, plastics, etc.
Once the exhaust pipe has been installed, do not stand behind the silencer when you start up the motorcycle for the rst
time.
MOUNTING
1- Remove the original silencer.
2- Attach the spare silencer to the cylinder and the original couplings, gently tightening the set of bolts.
3- When the assembly is completed, fully tighten all bolts and hooks to the manifold.
4- Start up the motorcycle and check that there is no gas leakage.
Any modication or alteration of the approved exhaust silencer is prohibited, in which case Yasunimotor S.L. waives any li-
ability concerning or related to the use of material that has lost the benets of the standardisation. In addition, Yasunimotor
S.L. waives any liability arising from defects and malfunction of the altered or modied product. It is highly recommended
to use a qualied technician for the assembly and operation of exhaust systems for motorcycles, as Yasuni is not liable for
any damages caused by an improper assembly of the exhaust. It is necessary to carry out an inspection of the hooks after
100 km of use. To obtain optimal performance, you should check the carburetion of your vehicle according to its state of
repair and conditions. It is normal that, after installing the silencer, it will emit white fumes. This phenomenon may occur
for the rst 100 km after installation.
* The spring clips of the silencer and the cone manifold may not be completely aligned
MAINTENANCE
Regularly inspect the silencer supports and all the elements which may suffer from wear and tear due to use. A possible
change of the colour of the silencer is normal, as this phenomenon is caused by the high temperatures that the product
reaches. Proper maintenance involves the use of specic products, so cleaners containing acidic additives should not
be used.
NON-CONTRACTUAL DOCUMENT.
Yasunimotor S.L. reserves the right to make all necessary modications without prior notice in order to improve the quality
of its products.
To Next Page
Loading...
Need help?
General
