To Next Page

To Previous Page

Basic Call Features

Placing a Call

Answering a Call

Using the handset:

Using the speakerphone:

Using the headset:

Using the handset:

Using the speakerphone:

Using the headset:

1. With the handset on-hook, press

1. Pick up the handset.

2. Enter the number, and then press the Send soft key.

1. With the headset connected, press to activate the headset mode.

2. Enter the number, and then press the Send soft key.

Pick up the handset.

Press .

Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by

Ending a Call

Call Mute and Un-mute

Redial

Call Hold and Resume

To place a call on hold:

Using the handset:

Using the speakerphone:

Using the headset:

Hang up the handset or press the End Call soft key.

Press or the End Call soft key.

Press the End Call soft key.

Press to enter the placed call list, press or to select the desired entry, and then press or

the Send soft key.

Press twice when the phone is idle to dial out the last dialed number.

Press to mute the microphone during a call.

Press again to un-mute the call.

Press the Hold soft key during an active call.

Note: You can reject an incoming call by pressing the Reject soft key.

To resume the call, do one of the following:

If there is only one call on hold, press the Resume soft key.

pressing the Headset key, the Speakerphone key or by picking up the handset. Headset mode requires

a connected headset.

Yealink SIP-T44W User Manual

Questions and Answers: